Siemens SIMATIC S7-1200 - Page 268

Basic instructions
8.6 Move operations
S7-1200 Programmable controller
268 System Manual, V4.2, 09/2016, A5E02486680-AK
Table 8- 73 Condition codes for the MOVE_BLK_VARIANT instruction
RET_VAL
(W#16#...)
Description
0000
No error
80B4 Data types do not correspond.
8151
Access to the SRC parameter is not possible.
8152
The operand at the SRC parameter is an invalid type.
8153
Code generation error at the SRC parameter
8154
The operand at the SRC parameter has the data type Bool.
8281
The COUNT parameter has an invalid value.
8382 The value at the SRC_INDEX parameter is outside the limits of the
Variant.
8383 The value at parameter SRC_INDEX is outside the high limit of the
array.
8482 The value at the DEST_INDEX parameter is outside the limits of
the Variant.
8483 The value at parameter DEST_INDEX is outside the high limit of
the array.
8534
The DEST parameter is write-protected.
8551
Access to the DEST parameter is not possible.
8552
The operand at the DEST parameter is an invalid type.
8553
Code generation error at the DEST parameter
8554
The operand at the DEST parameter has the data type Bool.
*You can display error codes in the program editor as integer or hexadecimal values.