Technology instructions
10.3 Motion control
S7-1200 Programmable controller
762 System Manual, V4.2, 09/2016, A5E02486680-AK
Table 10- 84 Example 2 - Aborting the task
If "Execute" = FALSE before the task is aborted
If "Execute" = FALSE after the task is aborted
The task is started with a positive edge at the input parameter "Execute". Depending on the programming, "Execute"
can still be reset to the value FALSE during the task, or the value TRUE can be retained until after completion of the task.
② While the task is active, the output parameter "Busy" indicates the value TRUE.
③ During task execution, the task is aborted by another motion control task. If the task is aborted, output parameter
"Busy" changes to FALSE and "CommandAborted" to TRUE.
④ If "Execute" retains the value TRUE until after the task is aborted, then "CommandAborted" also remains TRUE and
changes its value to FALSE together with "Execute".
⑤ If "Execute" has been set to FALSE before the task is aborted, "CommandAborted" indicates the value TRUE for only
To Next Page
Loading...
