Spectra T50e - Page 101

Chapter 4—Configuring the Library Configuring the Global System Settings
August 2017 User Guide—Spectra T50e Library
102
Set the IP Addressing
UsethefollowingstepstoconfigurethelibraryforEthernetnetwork
access.
1. Logintothelibraryasauserwithsuperuseroradministrator
privileges.
2. Ifnecessary,clickMENUtodisplaytheMenuscreen.
3. ClickConfigurationtodisplaytheConfigurationmenu.
4. OntheConfigurationmenu,clickMore Options(downarrow)to
displayadditionalconfigurationoptions.
5. Click Network.TheNetw orkscreendisplays.Thisscreenchanges
dependingonwhetherthelibraryisconfiguredtouseDHCPorStaticIP
addressing.
6. Decidewhichtypeofaddressingyouwantthelibrarytouse.
 DHCP(defaultsetting)—ThelibraryisissuedanIPaddressbythe
DHCPserver.
 Static(highlyrecommended)—ThelibraryusesafixedIPaddress.
Ifyouselectstaticaddressing,enterthefollowinginformation:
7. ClickSavetochangetheIPaddressing.
Note: Thelibrary’sIPaddresschangesassoonasyouclickSave.Asa
result,ifyouareconnectedtothelibrarythroughtheBlueScale
webinterfacetheconnectiontothelibraryislost.Reconnectto
thelibraryusingthenewIPaddress.Logintothelibraryto
continueusingtheBlueScalewebinterface.
Figure 56 Use the Network screen to configure the IP addressing for the library.
For this field... Enter...
Address AvalidIPaddressintheformnnn.nnn.nnn.nnn.
Subnet Thesubnetmask.Thesubnetmaskmustbeavalidoctetintheform
nnn.nnn.nnn.nnn.
Gateway Avalidnetworkgatewayaddressintheformnnn.nnn.nnn.nnn.Enter0.0.0.0for
theGatewayifyournetworkdoesnotuseagateway.