Spectra T50e - Confirm and Save the Partition Settings

Chapter 6—Configuring and Managing Partitions Creating a Storage Partition
August 2017 User Guide—Spectra T50e Library
181
2. Selectthetypeofencryptionyouwouldliketoenable:
Specify the Partition Users
1. FromtheMLMMediaVerificationscreenortheEncryptionscreen,
clickNext.ThePartitionUsersscreendisplays.
2. Selecttheuserswhoareallowedaccesstothispartition.Onlyusers
whoarealreadyconfiguredcanbeselected(see
ConfiguringLibrary
Usersonpage96).
Note: Alloftheuserswhoareconfiguredwithoperatorprivilegesare
listedunderAllow only.Selectoneormoreoftheseusersto
enablepartition‐basedsecurityforoperators.Superusersand
administratorsalwayshavefullaccesstoallpartitions.
Type Configures the partition to...
No Encryption Turnoffencryption.Noneofthedatainthepartitionisencrypted.Thisisthe
defaultsetting.
Spectra SKLM
Encryption
TurnonSpectraSKLMEncryptionkeymanagementfordrive‐basedencryption
usingdirect‐attachedLTO‐5andlatergenerationdrives.
Note: IfPostScanwasenabledontheMLMMediaVerificationscreen,Spectra 
SKLMEncryptioncannotbeselected,andisgrayedout.
BlueScale
Encryption
TurnonBlueScaledrive‐basedencryptionusingdirect‐attachedLTO‐4and
latergenerationdrives.Allkeymanagementtasksareperformedthroughthe
BlueScaleuserinterface.
Note: IfyouhaveBlueScaleEncryptionProfessionaleditionandmultiple
encryptionkeysconfiguredonthelibrary,selecttheprimarykeyforthe
partition.Thiskeyisusedwhenencryptinganddecryptingdata.Then,Select
none,one,ormultipleadditionalkeystobeassociatedwiththepartitionfor
decryptingdata.Amaximum
ofeightdecryptionkeyscanbeassignedtoone
partition.
Figure 116 Select which users access the partition.