Spectra T50e - Remove the Shipping Lock

Chapter 2—Installing the Library Installing the Library
August 2017 User Guide—Spectra T50e Library
51
4. Placethelibraryonasolid,levelsurfaceinalocationwithgoodairflow
fromthefrontofthelibrarytotheback.
Remove the Shipping Lock
Theshippinglock,whichpreventstheroboticsfrommovingduring
shipmentandinstallation,mustberemovedbeforethelibraryispowered
on.Theshippinglockislocatedinthetopcenterofthelibraryandisheld
inplacewithasmalllabel.
1. Removethetapelabelholdingthelockinplace,thenremovethelock.
2. Replacethelabelovertheopening.
3. Slidethelockintothestorageslotonthebackofthelibrary.
Note: Youneedtoreinstalltheshippinglockifyoumoveorshipthe
library.
4. Youarenowreadytoinstallthedrives.
Important
Make sure that all six feet are firmly in contact with the surface and that the top of
the library is level.
Caution
Failure to remove the shipping lock before powering on the library can cause
damage to the library.
Important
Unless you are not able to access the top of the library when it is installed in a rack,
do not remove the shipping lock until after you complete the installation.
Figure 14 The shipping lock must be removed before powering on the library.
1. Remove the label.
2. Remove the lock.
3. Replace the label.





4. Store the lock.