Spectra T50e - Page 50

Chapter 2—Installing the Library Installing the Library
August 2017 User Guide—Spectra T50e Library
50
Usethefollowingstepstopreparethelibraryforuseonatabletopsurface.
1. Ifdesired,removethemountingbracketsinstalledatthefrontofthe
libraryandtheguiderollersinstalledonthetw osides ofthelibrary
usingaT10Torxdriver.Setthebracketsandguiderollersaside.They
mustbereinstalledifyoudecidetorack‐mountthelibraryatalaterdate.
2. Carefullytipthelibraryontoitssidetoaccessthebottomofthechassis.
3. Installtherubberfeetonthebottomofthelibraryasshownin
Figure13.Removethepaperbackingonthefeetandattachthemtothe
locationsindicatedbytheindentationsonthebottomofthechassis.
Important
Removing the brackets and roller guides is optional. If you select to remove them,
make sure that you:
 Reinstall the black screws you remove from the brackets; they secure the cover
to the chassis.
 Do not reinstall the silver screws after you remove the guide rollers.
Figure 13 Install the rubber feet when using the library on a tabletop or
desktop.
Indentations
Feet (6x)
Bottom of library
(6x)
Roller guide (1 each side)
Do not reinstall the silver screws.
Mounting bracket (1 each side)
Reinstall the black screws to secure the cover.
Caution
Make sure that the shipping lock is in place before you tip the library. Tipping the
library without the shipping lock in place results in severe damage to the robotics.
Caution
The feet distribute the weight of the cartridge magazines. Operating the library
without the feet while it is on a flat surface may cause problems with magazines
latching.