Spectra T50e - DATA STORAGE CAPACITY

Appendix C—Specifications Library Specifications
August 2017 User Guide—Spectra T50e Library
493
Power Specifications
Thissectiondescribesthepowerspecificationsforthelibrary.
Input Power Requirements
Thefollowingtableshowstheinputpowerrequirementsforthelibrary
withonetofourLTOtapedrivesinstalled.Eachinputmustbeprotected
byacircuitbreakerratedfor15amps.
WhenusingtheredundantACpowerconfiguration,connecteachpower
supplyinputtoaseparatebranchcircuit.Usingseparatecircuitsallowsfor
failoverintheeventofapowerfailureinoneofthecircuits.ThetwoAC
inputsmustbeonthesamephase,andthevoltagesmustbethesame
withinafewvolts.
Power Cord Specifications
Thepowercordincludedwiththelibraryisconsideredpartofthelibrary
andisnotintendedforusewithanyotherequipment.
Notes:  Thesupply‐endconnectorisconsideredthedisconnectfor
theunit.Makesurethatthesocket‐outletfortheAC
connectionsisinanaccessiblelocationnearthelibrary.
 TousethelibraryoutsideofNorthAmerica,thepowercord
mustmeetthespecificationsforthatcountry.
Electrical Rating Current Rating (Maximum)
100–127VAC,50/60Hz
200–240VAC,50/60Hz
a
a. Requires a 220–240 VAC AC power cord with a twist-lock male connector. See Power Cord
Specifications on page 493 for detailed information about power cord requirements.
4ampspercord
2ampspercord
Caution
The library is designed to be used on single phase power only. If the power sources
for the dual AC inputs are not on the same phase, damage to the library could result.
Part
Number
Power Input
Connector Style
Supply-end Connector
Style
Supply-end Connector
Appearance
Power Cordage
3136 IEC60320‐C13,
female
Standard
NEMA5‐15
110‐120V
(wallpowerconnector)
Three‐
conductor,
18
AWG
8296 IEC60320‐C13,
female
PDUConnection
IEC‐60320C14
110‐240V,50‐60Hz 
(librarypow erconnector)
Three‐
conductor,
16
AWG