Spectra T50e - CHAPTER 14 Maintaining the Library

Chapter 13—Drive Troubleshooting Using DLM to Test an LTO Drive
August 2017 User Guide—Spectra T50e Library
408
Run the DLM Drive Health Verification Wizard
UsethefollowingstepstolaunchtheDLMDriveHealthVerification
wizard.
1. Logintothelibraryasauserwithsuperuseroradministrative
privileges.
2. Cleanthedriveyouplantotest(seeCleaningaDriveonpage435).
3. ImportormoveascratchcartridgetotheE/Eslot(seeMoveCartridges
WithinaPartitiononpage219).
Note: IfyouusetheImport/Exportscreentoimportthecartridge,do
notmovethecartridgetoaslot;leaveitintheE/Eslot.
4. ClickMENU > Configuration > DLMtodisplaytheDrivesscreen.
Note: TheTestbuttonisnotpresentifDLMisnotenabled.
Figure 277 Click Test on the Drives screen to launch the
wizard.