Spectra T50e - Configure Mail Users

Chapter 4—Configuring the Library Configuring the Global System Settings
August 2017 User Guide—Spectra T50e Library
104
Configure Mail Users
Mailusersarethepreconfiguredrecipientsofemailnotificationsgenerated
bythelibrary.Thelibrarycanautomaticallysendemailnotificationsto
selectedmailuserswheneveraspecifiedmessagetypeisgenerated.Email
notificationscanalsobesentondemandwhentracesarerun,reportsare
generated,orthelibrary’sconfigurationdataisbackedup.Theemail
includesattachmentscontaininganysystemmessages,traces,or
diagnosticresultsassociatedwiththenotification.Thelibrarycanalso
sendAutoSupportmessagestoselectedmailusers.
Note: Youmustconfigurethelibrary’sIPaddressasdescribedin
ConfigureNetworkSettingsonpage100beforeyoucan
configuremailrecipients.
1. Logintothelibraryasauserwithsuperuseroradministrator
privileges.
2. Ifnecessary,clickMENUtodisplaytheMenuscreen.
3. ClickConfigurationtodisplaytheConfigurationmenu.
4. ClickMail Users.TheMailUsersscreendisplays.
Note: Ifyoudonoconfigureanymailusers,thisscreenonlyshowsthe
defaultmailrecipientforSpectraLogicautosupport.
Important
You must edit the autosupport@spectralogic.com mail user to configure the SMTP
server if you want to open an AutoSupport ticket directly from the library (see
Chapter 11 – Configuring and Using AutoSupport, beginning on page 327). This
mail user is also used to send the ASL and HHM files that the library generates to
Spectra Logic Technical Support when troubleshooting a problem.
Figure 58 Use the Mail Users screen to configure mail
recipients.