Spectra T50e - Disabling Encryption in a Partition

Chapter 10—Encryption and Key Management BlueScale Key Management
August 2017 User Guide—Spectra T50e Library
323
5. TheEncryptionConfigurationscreenredisplayswithamessage
indicatingthatthekeywassuccessfullydeleted.Themonikerisno
longerlistedonthescreen.
Disabling Encryption in a Partition
Usethefollowingstepstodisableencryptioninapartition:
Note: Ifyouarenotalreadyloggedinasanencryptionuser,youmust
entertheencryptionpasswordbeforeyoucreateoredita
partitionusingtheBlueScalepartitionwizard.Ifyouarenot
loggedin,theEncryptionscreendoesnotdisplay.
1. AccesstheBlueScalepartitionwizard(seeAccessingthePartition
Wizardonpage164).
2. Selectthepartitionforwhichyouwanttodisableencryption.ClickEdit.
3. ClickNexttonavigatethroughthepartitionwizardscreensuntilyou
reachtheEncryptionscre en(seeFigure199onpage305).
4. SelectNo Encryption.
5. ClickNexttomovetothenextpartitionconfigurationscreen.Navigate
throughtheremainingpartitionconfigurationscreensbyclickingNext.
6. WhenyoureachtheSummaryscreen,clickSave.
Figure 216 The Encryption Configuration screen shows that
the key was successfully deleted.