Spectra T50e - PERFORM THE AUTOINSTALL

Chapter 2—Installing the Library Perform the AutoInstall
August 2017 User Guide—Spectra T50e Library
62
PERFORM THE AUTOINSTALL
ThespeciallypreparedSpectraUSBdevicethatcameinyourdocumentkit
(seeInventorytheComponentsonpage43)containsthemostcurrent
versionoftheBlueScalesoftwareforthelibrary,aswellastheactivation
keysfortheoptionsthatyoupurchasedwiththelibrary.Itisusedto
automaticallyupdatetheBlueScalesoftwaretoandloadtheactivation
keysintothelibrary.
Notes:  Ifthisistheinitialinstallation,thatis,ifyouhavenotalready
installedthelibrary,followthestepsinthissectiontoupdate
theBlueScalesoftwareandinstalltheactivationkeysforthe
optionsthatyoupurchased.
 IfyouneedtoenteroptionkeysaftertheAutoInstallsetup—
seeEnterActivationKeysonpage113forinstructions.
 AftercompletingthisinitialAutoInstallprocess,see
UpdatingtheBlueScaleSoftwareandLibraryFirmwareon
page414forinstructionsforsubsequentupdatestothe
library’sBlueScalesoftware.
Usethefollowingsteps toautomaticallyupdatetheBlueScalesoftwareand
loadtheactivationkeysintothelibrary.
1. PlugtheSpectraUSBdeviceintooneoftheUSBportsonthebackof
thelibrary.
Figure 25 Plug in the Spectra Logic USB device to
perform the AutoInstall.
Plug in
USB device