Spectra T50e - Page 63

Chapter 2—Installing the Library Perform the AutoInstall
August 2017 User Guide—Spectra T50e Library
63
2. PluganACpowercordintotheACconnectoronthepowersupply
module.Makesurethatthecordisfullyseatedintheconnector.Ifyour
libraryhastwopowersupplies,connecttheredundantpowersupply
aswell.
3. ConnectthefreeendofeachpowercordintoaproperlygroundedAC
poweroutlet.
4. Foreachpowersupply,confirmthattheACandDCpowersupply
statusLEDs(seeFigure5onpage29)illuminateblueandgreen,
respectively,andthattheFaultLEDisnotilluminated.
5. Pressandholdthefrontpanelpowerbuttonfortwotothreeseconds
untilthebutton’sLEDilluminates.
6. Waitwhilethelibraryperformsitspower‐onsequence,whichtypically
takesfromsixtonineminutes.
7. Ifthisisthefirsttimeyoupower‐onthelibrary,thetouchscreen
calibrationutilityruns.Usethestylustocalibratethetouchscreen
followingtheinstructionsprovidedonthescreen.
Thecalibrationsteponlyoccursduringtheinitialpower‐on.Youcan
alsomanuallystartthecalibrationprocess(see
CalibratingtheTouch
Screenonpage431).
Important
For redundant AC power configurations, connect each input to a separate branch
circuit, which allows for failover in the event of a power failure in one of the circuits
(see
Power Specifications on page 493 for additional requirements).
Figure 26 Connect the AC power cords (redundant power supply shown).
Figure 27 Press and hold the front panel power button.
AC power cord
Redundant
power supply
Primary
power supply
Power button