Chapter 2—Installing the Library Installing the Library
August 2017 User Guide—Spectra T50e Library
48
3. Usinga#2Phillipsscrewdriver,installfourM6screws—twointhe
frontandtwointherear—tosecuretherailtotherack(Figure11, ).
Tightenthescrewssecurely.
Notes: TwosetsofM6screwsareprovided.Thetypeyouuse
dependsonthetypeofrackyouhave.Usethescrewswith
thelargershoulderforrackswithsquareholes.
Tosimplifytheinstallation,haveasecondpersonsupportthe
railwhileyouinstallthescrews.
Leavethemiddleholeineachrailempty.Youusethishole
whenattachingthelibrary’smountingbracketstotherack.
4. RepeatStep1onpage47throughStep3onthispagetoinstallthe
right‐siderail.
Note: Makesureyouinstalltheright‐siderailatthesamelevelasthe
left‐siderailsothattheshelfformedbytherailsislevelfrom
righttoleftandfronttobackintherack.Otherwise,thelibraryis
notlevelwhenitisinstalledintherack.
Usingalevelsimplifiesmakingsurethattherailsarelevelfrom
lefttoright.
Place the Library in the Rack
1. Liftthelibraryontotheshelfformedbytherails.
Note: Ifyouarenotbeabletoaccessthetopofthelibraryafteritis
installedintherack,youmustremovetheshippinglockbefore
placingthelibraryintherack(see
RemovetheShippingLockon
page51).
2. Slidethelibrarycompletelyintotheracksothatthemountingbrackets
areagainsttheposts.
Do not install the rubber feet if you are installing the library in a rack, as they are
meant for a tabletop installation only! See
Install the Library on a Flat Surface on
page 49 for a description of the rubber feet.
Do not remove the shipping lock from the library until after you complete the rack
installation. If access constraints require you to remove the lock, keep the library as
level as possible as you lift it into the rack. Tipping the library without the shipping
lock in place may result in severe damage to the robotics.