Spectra T50e - Page 47

Chapter 2—Installing the Library Installing the Library
August 2017 User Guide—Spectra T50e Library
47
Install the Rails in the Rack
Note: Ifpossible,positiontherailsintherackmidwayuptherackso
youhaveeasyaccesstothelibraryfrontpanel.
1. Positiontheleft‐siderailassemblyintheracksothatthefrontflangeis
behindthefrontscrewholesintherackpost(Figure11, ).
Note: Makesurethatthefrontandbackoftherailareattachedtothe
rackatthesameheightonthefrontandbackposts.Otherwise
thelibraryisnotlevelwheninstalledintherack.
Usingalevelsimplifiesmakingsurethattherailislevelfrom
fronttoback.
2. Usingtheslider,adjustthelengthoftherailassemblyasnecessarytofit
thedepthoftherack(
Figure11, ).
Caution
Make sure that the rails and the library are level from front to back and from side to
side. If the library is not level when you begin using it, robotic errors could result.
Figure 11 Install the rails in the rack.
Front of Rack—Left Side
Back of Rack—Right Side
Adjustable slider
1
2
3
Position front flange of rail
assembly against back of
rack post.
Note: Install rail
with angled edge
toward back of rack.
Adjust rail length
to depth of rack.
Adjust rail length
to depth of rack.
Use screws to secure
the rail to the rack.
2
1
2