Spectra T50e - Verify the Configuration Backup

Chapter 4—Configuring the Library Backing Up the Library Configuration
August 2017 User Guide—Spectra T50e Library
119
9. ClickNexttoselectwheretosendtheutilityresultssystemmessage.
Note: TheDestinationsscreenspecifieswheretosendtheutility
resultssystemmessage.Itdoesnotaffectwheretheactual
configurationbackupfileissent.
10. ClickRun.
Afterabriefdelay,theUtilityResultsscreenredisplays,showingthat
theconfigurationfilewassenttotheselecteddestination.
11. Confirmthatthebackupwassuccessful,asdescribedinVerifythe
ConfigurationBackup.
Verify the Configuration Backup
Aftercreatingabackupofyourlibraryconfiguration,useoneofthe
methodsdescribedinthefollowingsectionstoverifythatthebackupwas
successfulassoonaspossibleafteryoucreateit.
When Saved to a USB Device
1. PlugtheUSBdeviceintoaUSBportonanavailablecomputer.
2. ExaminethelistoffilesontheUSBdeviceandlocatethe
\SavedConfigsfolder.
3. Openthe\SavedConfigsfolderandverifythatafolder
correspondingtothedateandtimeyoucreatedthebackupispresent.
Figure 69 Select additional destinations for the utility results file.
Note: Do not use the
autosupport@spectralogic.com
address unless specifically
instructed to do so by Spectra
Logic Technical Support.