Spectra T50e - Configuring Spectra SKLM Key Management

Chapter 10—Encryption and Key Management Spectra SKLM Key Management
August 2017 User Guide—Spectra T50e Library
289
Configuring Spectra SKLM Key Management
UsethefollowingstepstoconfigurethelibrarytouseSpectraSKLMkey
management.
User Privilege Requirements Onlyuserswithsuperuserprivilegescan
configuretheencryptionfeatures.
Configure the Spectra SKLM Server
1. Accesstheencryptionfeature(seeLogIntotheEncryptionFeatureon
page284).
2. OntheEncryptionConfigurationscreen,clickSpectra SKLM.The
SpectraSKLMServerStatusscreendisplays.
3. TheSpectraSKLMServerStatusscreendisplaysalistofpreviously
configuredSpectraSKLMservers(ifany).UptofourSpectraSKLM
serversaresupported;eachislistedbyitsIPaddress.
Note: Whenreadorwriteprocessesbegin,agreencheckmarkappears
intheStatuscolumnnexttoserversthelibrarycanaccess.Ared
XintheStatuscolumnindicatesthelibraryiscurrentlyunableto
connecttothatserver.
OntheSpectraSKLMServerStatusscreen,clickEdit toaddormodify
SpectraSKLMservers.
Caution
The encryption password is separate from the password used to log into the library.
Make sure you keep a record of this password. If you lose this password, you are not
able to access the library encryption configuration screen.
Figure 191 Access the Spectra SKLM Server Status screen.
Figure 192 Click Edit to add or modify a server.