Spectra T50e - Enable and Configure MLM Prescan and Postscan

Chapter 6—Configuring and Managing Partitions Creating a Storage Partition
August 2017 User Guide—Spectra T50e Library
177
Enable and Configure MLM PreScan and PostScan
WhenMLMisenabled,youcanconfigurethepartitiontousetheMLM
PreScanandPostScanfeatures.
Notes:  MLMisenabledbydefault.IfyouwanttousePreScanand
PostScanbutdonotseetheMLMMediaVerificationscreen,
checktoseeifMLMisdisabled(seeEnablingMLMand
ConfiguringGlobalSettingsonpage235).
 Theavailablefeaturesdependonthedriv etypeusedinthe
partition.SeeUsingPreScanon page245andUsingPostScan
onpage247forinformationaboutthesefeatures.
UsethefollowingstepstoconfigurethePreScanandPostScanfeatures
usedinthepartition.
1. FromtheChambersandDrivesscreen,clickNext.TheMLMMedia
Verificationscreendisplays.
Note: IfyoudonotwanttousethePreScanandPostScanfeatures,
clickNextagainandskipto
ConfigureEncryptiononpage180.
Drive Type PreScan
PostScan
Drive
Firmware
Required
FullScan QuickScan
QuickScan with
Global Spares
LTO-3 , SCSI available unavailable unavailable unavailable 93G0orlater
LTO-3 , Fibre Ch annel available unavailable unavailable unavailable 93G0orlater
LTO-4 , Fibre Ch annel available available available available 97F9orlater
LTO-5, Fibre Channel and SAS available available available available B170orlater
LTO-6, Fibre Channel and SAS available available available available C9T4orlater
LTO-7, Fibre Channel and SAS available available available available FA11orlater