Spectra T50e - Restore the MLM and DLM Databases

Chapter 12—Library Troubleshooting Restoring the Library Configuration
August 2017 User Guide—Spectra T50e Library
374
10. Reviewtheinformationonthescreenandconfirmthatallsettingsare
correctforthispartition’sconfiguration.
 Iftheconfigurationinformationiscorrect,proceedtoStep11.
 Iftheconfigurationinformationisnotcorrect:
 ClickCancelandconfigurethepartitionagainfromthebeginning.
—OR—
 ClickPrevioustomovebackwardthroughtheconfiguration
screensuntilyoureachthesettingsthatneedcorrection.Make
anynecessarycorrections,thenclickNexttomoveforward
throughthescreensandreturntotheSavePartitionscreen.
11. ClickSave.Thelibraryrequiresseveralminutestostorethe
configurationinformation,afterwhichthePartitionsscreenredisplays.
Note: Whenyoumakeachangetoapartition,thelibrarygeneratesan
AutoConfigurationSavebackupfileandsavesittotheLCM
memorycard.Ifyouconfiguredtheemailoptionforthe
automaticallygeneratedbackupfile,thelibrarysendsanemail
withthebackupfileattachedtothespecifiedrecipient(seeEmail
AutoConfigurationSaveonpage109).
Restore the Library Configuration Using a Saved Configuration
Usethefollowingstepsifyouwanttorestorethelibraryfroma
configurationbackupfilethatwasgeneratedmanually,asdescribedin
BackUptheLibraryConfigurationManuallyonpage116.
Note: Themanually‐generatedconfigurationbackupfilesdonot
includetheMLMandDLMdatabases.Ifyoualsoneedtorestore
theMLMandDLMdatabases,youmustuseaseparately
generatedbackupoftheMLMdatabase(see
RestoretheMLM
andDLMDatabasesonpage377).
1. Ifyouplantorestoreusingaconfigurationbackupfilethatwassentas
anemailattachment,usethefollowinginstructionstocopyittoaUSB
device;otherwise,skipto
Step2.
a. Createafoldercalled\SavedConfigs\<date-time>folder,where
<date-time>isthetimestampforthezipfileyoureceivedinthe
email.
b. Copythezipfileyoureceivedintheemailtothe
\SavedConfigs\<date-time>folderontheUSBdevice.
2. Iftheconfigurationbackupfileyouareusingtoperformtherestoreis
onaUSBdevice,inserttheUSBdeviceintoaUSBportontheLCMand
allowtimeforthedevicetomount;otherwise,skiptothenextstep.
Note: TheoptiontorestorefromUSBisonlyavailableifyouconnect
theUSBdevicetotheLCMbeforeyouselect Show Advanced(see
Figure90onpage148).