Spectra T50e - Page 376

Chapter 12—Library Troubleshooting Restoring the Library Configuration
August 2017 User Guide—Spectra T50e Library
373
5. ClickNexttoadvancethroughthepartitionwizardscreensuntilyou
reachtheChambers&Drivesscreen.
6. Decreasethenumberofslotsassignedtothepartitionbythenumberof
cartridgesthelibraryreportedasunassigned.
7. ClickNexttoadvancethroughtheremainderofthescreenswithout
makinganyadditionalchangesuntilyoureachtheSummaryscreen.
8. ClickSave.ThePartitionsscreenredisplays.
9. RepeatStep2throughStep7,thistimeincreasingthenumberofslots
assignedtothepartitiontotheoriginalnumber.Thecartridgesthat
werereportedasunassignedareassignedtothepartition.
Figure 256 Adjust the number of slots assigned to the
partition.
Important
If the library has multiple partitions and you imported cartridges into all of the
partitions after the configuration backup file you used to restore the library was
generated, the cartridges can potentially end up in the wrong partition. Carefully
examine the cartridge inventory for each partition. Export any wrongly assigned
cartridges and reimport them into the correct partition.