Spectra T50e - Install the Library on a Flat Surface

Chapter 2—Installing the Library Installing the Library
August 2017 User Guide—Spectra T50e Library
49
3. Usinga#2Phillipsscrewdriver,installoneM5screwineachmounting
brackettosecurethelibrarytotherack,asshownhere.
4. SkiptoRemovetheShippingLockonpage51tocompletethe
installation.
Install the Library on a Flat Surface
Figure 12 Attach the library to the rack.
Mounting
bracket screw
Caution
Do not remove the shipping lock from the library until after you position the library
on the tabletop surface where it operates.
Caution
When using the library on a tabletop surface, keep the following requirements in
mind:
 The library must be installed on a level surface. If the library is not level when
you begin using it, the robotics may experience errors.
 Do NOT stack any items on top of the library as it restricts the movement of the
robotics.
Caution
The maximum ambient temperature of the library is 95° F (35° C). Ensure that you
select a location where the air vents at the front of the library and the fans at the
back of the library are not blocked. The library requires unobstructed airflow to stay
properly cooled.