Spectra T50e - Page 64

Chapter 2—Installing the Library Perform the AutoInstall
August 2017 User Guide—Spectra T50e Library
64
8. WaitwhiletheAutoInstallprocesscompletes.DuringtheAutoInstall
process,thelibraryautomaticallyupdatestheBlueScalesoftwareand
reboots.
9. Afterthereboot,waitwhilethelibrarycompletesitspower‐on
sequence,whichtakessixtonineminutes,dependingonthelibrary
configuration.Afterthelibrarycompletesitspower‐onsequence,the
LibraryInitializationscreendisplays.
Thisscreenliststherequiredinitializationstepsandcurrentstatusof
thelibrary’smajorcomponents(Robotics,RCM,andLCM).Textboxes
providedescriptionsaboutthecurrentlyactivetasks.
Note: IfyourlibraryhasastaticIPaddress,youcanaccessthelibrary
usingtheremotelibrarycontroller(RLC)assoonastheLibrary
Initializationscreendisplays.
10. AfterthelibrarycompletesitsinitializationsequenceandtheLogin
screendisplays,removetheSpectraUSBdevicefromthelibrary.
Note: Ifthelibrarycannotcompletetheinitializationprocess,it
generatessystemmessagesandentersmaintenancemode.
ContactSpectraLogictechnicalsupportforassistance.
Figure 28 The Library Initialization screen.
Completed task
Active task
Task not started
Task description(s)
Important
Do not remove the USB device until the Login screen appears, but do not leave the
USB device in the library after the installation.