Spectra T50e - Page 61

Chapter 2—Installing the Library Installing Capacity Expansion Slots (Optional)
August 2017 User Guide—Spectra T50e Library
61
Usethefollowingstepstoinstallacapacityexpansionslotinthelibrary.
Note: Thecapacityexpansionslotscanbeinstalledatanytime.Ifyou
arereplacingapreviouslyinstalledhalf‐heightdrive,first
removethedriveasdescribedinRemovingaDrivefromthe
Libraryonpage462.
1. Accessthebackofthelibrary.
2. Usinga#2Phillipsscrewdriver,removeoneofthedrivebaycover
plates.Setthecoverandscrewsasideforfutureuse.
Note: Usethefirstavailablelocationgoingfrombottomtotoptoadd
expansionslots.Donotleaveemptydrivebaysbetweenthe
drivesandthecapacityexpansionslot.SeeFigure22.
3. Slidetheexpansionslotintothelibraryand,usingyourfingersora
#2Phillipsscrewdriver,tightenthecaptivescrewstosecureittothe
chassis.
Figure 23 Remove the cover from the drive bay where you want to install the capacity
expansion slot.
Screws
(two per cover)
Drive bay
cover
Figure 24 Slide the capacity expansion slot into the empty drive bay.
Captive screws