Spectra T50e - Page 362

Chapter 12—Library Troubleshooting Capturing Traces
August 2017 User Guide—Spectra T50e Library
359
4. Dependingonthecategoryoftraceyouneedandwhichcategoryis
currentlydisplayed,clickShow ComponentorShow LCMtoselectthe
categoryoftracestoview.
 LCM Traces—Captureslogfilesrelatingtoasingleaspectof
operationsrelatedtotheLCM.
 Component Traces—Capturesatracerelatingtothelogicallibrary
orasingleaspectofoperationsrelatedtotherobotics.
5. Selectthetraceyouwanttocapturefromthelistoftraces,thenclick
Select.TheErrorLogscreenfortheselectedtracedisplays.
6. Usethecheckboxestoselectanycombinationoftheoptionsforsaving
thegeneratedtrace.
Figure 243 Select the destination for the captured trace
(Error Log screen shown).
Option Description
Send results to Mail
User
Sendsthetracereporttoapreviouslyconfiguredmailrecipient.Usethedrop‐
downlisttoselecttherecipientforthereportfile.
Onlypreviouslyconfiguredmailrecipientsarelisted.Tosendtheemailwith
theattachedtracefiletosomeonewhoisnotlisted,exittheutility,configure
thatpersonasamailuser(see
ConfigureMailUsersonpage104),andthenrun
theutilityagain.
Note: Donotselectautosupport@spectralogic.comasarecipient.Spectra
Logicdoesnotsaveemailedtracesunlesstheyarespecificallyrequestedfor
troubleshooting.
Save to USB SavesthereporttotheUSBdevice. Theresultscanthenbeviewedfromany
devicethatcanreadfromUSB.
Note: ThisoptionisonlyavailableifyouinsertedaUSBdeviceinStep2on
page358.