Spectra T50e - OPENING A SUPPORT INCIDENT

Chapter 15—Maintaining the Drives Removing a Drive from the Library
August 2017 User Guide—Spectra T50e Library
463
3. ClickMENU,thenselectConfiguration > DLM (orDrivesifDLMisnot
enabled)toviewalistofallthedrivescurrentlyinstalledinthelibrary.
4. ClickRemovenexttothedrivethatyouwanttopermanentlyremove
fromthelibrary.
AFeedbackRequiredscreenpromptsyoutoconfirmthatyouwantto
removethedrive.
5. ClickOK.Waitforthelibrarytopoweroffthedrive.
6. WatchthefrontpanelforaFeedbackRequiredscreenindicatingthat
thedrivewassuccessfullyshutdown.
7. Removethedrive.
a. Accessthebackofthelibraryandidentifythedriveyouneedto
remove.
Note: SeeIdentifytheDrivesintheLibraryonpage149todetermine
thephysicallocationthatcorrespondstothedriveidentifierfor
thedriveyouareremoving.
b. DisconnecttheinterfacecableandtheSCSIterminator,ifoneis
installed,fromthedrive.
c. Loosenthe captivescrewssecuringthedrivesledto thelibrary
chassis,graspthehandle,andpullthedrivestraightoutofthelibrary
whilesupportingit withbothhands(seeFigure317onpage461).
Figure 318 Click Remove next to the drive you want to
permanently remove from the library.
Important
Do not respond to the prompt in the Feedback Required screen or perform any
other operations from the user interface (either locally or remotely) until you
complete the removal procedure. If you respond before you remove the drive the
drive you just powered down powers on and configures itself.