Spectra T50e - EMISSION STANDARDS

Appendix C—Specifications Tape Drive and Media Specifications
August 2017 User Guide—Spectra T50e Library
506
Printed Characters Thelabelcanhavehuman‐readablealphanumeric
charactersprintedalongthetoporbottomedgeofthelabelprovidedthere
isnoconflictorinterferencewiththeautomationcode.Thistextmust
includethebarcodedata,butcanalsoincludeadditionaltext.Theformat
andcolorsofthehumanreadablecharactersisuptothecustomerand
labelvendor .Forlocationrestrictions,seeDetailedSpecificationson
page507.
Note: Whenusingbarcodelabelswithalphanumericcharactersalong
thebottomedge,thelabelmustbepositionedsothatbarcodeis
atleast13.72mmbelowthetopedgeofthecartridgetoensure
thatthebarcodereadercanreadthelabel.
Dimensional Specifications Figure327showsthedimensi onal 
specificationsforlabels withthealphanumericcharactersabovethebarcode.
Important
The barcode label must only have one barcode on it. If multiple barcodes are
present, the library’s barcode scanner cannot determine which one to process
when scanning the cartridge.
Figure 327 Barcode specifications for half-inch media; alphanumeric characters on top.
Alphanumeric
Barcode start character
11.1 mm,
minimum
17 mm
+0/–0.8
Quiet zone
characters
79 mm +0/–0.8
74.088 mm, nominal
4.32 mm,
Quiet zone
4.32 mm,
minimumminimum
Barcode stop character