RM0440 Rev 4 219/2126
RM0440 Embedded Flash memory (FLASH) for category 2 devices
228
Bit 31 LOCK: FLASH_CR Lock
This bit is set only. When set, the FLASH_CR register is locked. It is cleared by
hardware after detecting the unlock sequence.
In case of an unsuccessful unlock operation, this bit remains set until the next
system reset.
Bit 30 OPTLOCK: Options Lock
This bit is set only. When set, all bits concerning user option in FLASH_CR
register and so option page are locked. This bit is cleared by hardware after
detecting the unlock sequence. The LOCK bit must be cleared before doing the
unlock sequence for OPTLOCK bit.
In case of an unsuccessful unlock operation, this bit remains set until the next
reset.
Bit 29 Reserved, must be kept at reset value
Bit 28 SEC_PROT1: Securable memory area protection bit.
This bit is set to lock the access to the Securable memory area. It is set by software
when exiting the Securable memory area, and can only be written once.
Bit 27 OBL_LAUNCH: Force the option byte loading
When set to 1, this bit forces the option byte reloading. This bit is cleared only
when the option byte loading is complete. It cannot be written if OPTLOCK is set.
0: Option byte loading complete
1: Option byte loading requested
Bit 26 RDERRIE: PCROP read error interrupt enable
This bit enables the interrupt generation when the RDERR bit in the FLASH_SR
is set to 1.
0: PCROP read error interrupt disabled
1: PCROP read error interrupt enabled
Bit 25 ERRIE: Error interrupt enable
This bit enables the interrupt generation when the OPERR bit in the FLASH_SR
is set to 1.
0: OPERR error interrupt disabled
1: OPERR error interrupt enabled
Bit 24 EOPIE: End of operation interrupt enable
This bit enables the interrupt generation when the EOP bit in the FLASH_SR is
set to 1.
0: EOP Interrupt disabled
1: EOP Interrupt enabled
Bits 23:19 Reserved, must be kept at reset value
Bit 18 FSTPG: Fast programming
0: Fast programming disabled
1: Fast programming enabled
Bit 17 OPTSTRT: Options modification start
This bit triggers an options operation when set.
This bit is set only by software, and is cleared when the BSY bit is cleared in
FLASH_SR.
To Next Page
Loading...
Need help?
General
