Stoll CMS ADF-3 - Page 253

253
5 Setup Data
5.4 Setup2 Editor
Y:Ncc (tab)  Control clamping depth
Further information:
 Table Tools [-> 244]
 File tools [-> 245]
 Helpers for Input [-> 239]
 Overview of the Setup2 Editor of the CMS [-> 237]
 Setup Data [-> 233]
 Comparing Setup1 to Setup2 [-> 235]
Width (tab) The M1plus enters the width of the inlay yarn carrier in the "Yarn carrier
carriage width" field.
Further information:
 Table Tools [-> 244]
 File tools [-> 245]
 Helpers for Input [-> 239]
 Overview of the Setup2 Editor of the CMS [-> 237]
 Setup Data [-> 233]
 Comparing Setup1 to Setup2 [-> 235]
Explanation Value range
NCC Control of the clamping depth of the clamping
and cutting needles.
Standard setting: n=0
e.g.: Lower the cutting needles by 5 steps:
NCC=5
Minimum value: -10
Maximum value: 10
Step width: 1
Comment Comment ASCII Characters