Texas Instruments TINSPIRE User Manual

Data Collection and Analysis 727
Defining Collection Mode as Selected Events
To set collection mode to Selected Events:
1. Select Experiment > Start Collection or click .
2. Select
Experiment > Keep or click for each data point you want
to keep.
3. Repeat step two until all data points you want to collect are selected.
4. Select Experiment > Stop or click after all points are selected.
The data point is captured for each selection. Data is visible in the
Graph and Table views.
Defining Collection Mode as Events with Entry
To set collection mode to Events with Entry:
1. Select Experiment > Start Collection or click .
2. Select
Experiment > Keep or click for each data point you want
to keep.
The Events with Entry dialog box opens.
3. Enter the independent value in the “Enter Value” field.
Note: Value is typically numeric, but you can also use text.
4. Click OK to continue.
5. Repeat steps two through four until all data points you want to
collect are selected.
6. Select Experiment > Stop or click after all points are selected.
The data point is captured for each selection. Data is visible in the
Graph and Table views.

Texas Instruments TINSPIRE Specifications

General

Brand	Texas Instruments
Model	TINSPIRE
Category	Calculator
Language	English