Data Collection and Analysis 759
Working with data and Table View
This section primarily involves working with your data sets in Table View.
This section’s topics include:
• Defining column options
• Changing a data set name
• Adding a new manual column
• Adding a calculated column
• Creating a new data set
Defining column options
Set the column name, units, and precision here. All existing columns are
listed.
To define the column:
1. Select View > Table or click .
You can be in the Meter, Graph, or Table views and still perform these
steps. The results will still be visible.
The Table View is displayed. In this example, no data sets have been
run and the Vernier Gas Pressure Sensor is attached.
To Next Page
Loading...
