84
Chapter 12 DoS Defend Commands
DoS (Denial of Service) Attack is to occupy the network bandwidth maliciously by the network
attackers or the evil programs sending a lot of service requests to the Host. With the DoS
Defend enabled, the switch can analyze the specific field of the received packets and provide
the defend measures to ensure the normal working of the local network.
12.1 ip dos-prevent
Description
The ip dos-prevent command is used to enable the DoS defend function
globally. To disable the DoS defend function, please use no ip dos-prevent
command.
Syntax
ip dos-prevent
no ip dos-prevent
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the DoS defend function globally:
T1600G-52TS(config)#ip dos-prevent
12.2 ip dos-prevent type
Description
The ip dos-prevent type command is used to select the DoS Defend Type.
To disable the corresponding Defend Type, please use no ip dos-prevent
type command.
To Next Page
Loading...
Need help?
General