239
27.14 ip igmp snooping multi-vlan-config
(source-ip-replace)
Description
This command is used to replace the multicast source IP address of the IGMP
packets in the specified multicast VLAN. To delete the forbidden router ports,
please use no ip igmp snooping multi-vlan-config replace-sourceip
command.
Syntax
ip igmp snooping multi-vlan-config [
vlan-id
] replace-sourceip
ip
no ip igmp snooping multi-vlan-config replace-sourceip
Parameter
vlan-id
——The ID of the multicast VLAN, ranging from 2 to 4094.
ip
—— Specify the IP address. The switch will use this IP address to replace
the source IP address of the IGMP packets.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Replace the source IP address of the IGMP packets in multicast VLAN 2 as
192.168.0.112:
T1600G-52TS(config)# ip igmp snooping multi-vlan-config 2
replace-sourceip 192.168.0.112
27.15 ip igmp snooping querier vlan
Description
The ip igmp snooping querier vlan command is used to enable the IGMP
Snooping Querier function of the VLAN(s). To disable the IGMP Snooping
Querier function of certain VLANs, please use no ip igmp snooping querier
vlan command.
Syntax
ip igmp snooping querier vlan
vlan-id
To Next Page
Loading...
Need help?
General