73
containing the MAC address of the Host. The MAC Verify feature is to
compare the two fields and discard the packet if the two fields are different.
Syntax
ip dhcp snooping mac-verify
no ip dhcp snooping mac-verify
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the MAC Verify feature for the Gigabit Ethernet port 10/2:
T1600G-52TS(config)#interface gigabitEthernet 1/0/2
T1600G-52TS(config-if)#ip dhcp snooping mac-verify
10.10 ip dhcp snooping limit rate
Description
The ip dhcp snooping limit rate command is used to enable the Flow Control
feature for the DHCP packets. The excessive DHCP packets will be discarded.
To restore to the default configuration, please use no ip dhcp snooping limit
rate command.
Syntax
ip dhcp snooping limit rate
value
no ip dhcp snooping limit rate
Parameter
value
—— The value of Flow Control. The options are 5/10/15/20/25/30
(packet/second). The default value is 0, which stands for “disable”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
To Next Page
Loading...
Need help?
General