TP-Link T1600G-52PS Cli Reference Guide

80
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the arp defend function for the Gigabit Ethernet ports 1/0/2-6:
T1600G-52TS(config)#interface range gigabitEthernet 1/0/2-6
T1600G-52TS(config-if-range)#ip arp inspection
11.4 ip arp inspection limit-rate
Description
The ip arp inspection limit-rate command is used to configure the ARP
speed of a specified port. To restore to the default speed, please use no ip
arp inspection limit-rate command.
Syntax
ip arp inspection limit-rate value
no ip arp inspection limit-rate
Parameter
value ——The value to specify the maximum amount of the received ARP
packets per second, ranging from 10 to 100 in pps(packet/second). By
default, the value is 15.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the maximum amount of the received ARP packets per second as
50 pps for Gigabit Ethernet port 5:
T1600G-52TS(config)#interface gigabitEthernet 1/0/5
T1600G-52TS(config-if)#ip arp inspection limit-rate 50

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English