TP-Link T1600G-52PS - Ip Address-Alloc

133
17.10 ip address-alloc
Description
The IP address-alloc command is used to enable the DHCP Client function or
the BOOTP Protocol. When this function is enabled, the specified interface
will obtain IP from DHCP Server or BOOTP server. To disable the IP obtaining
function on the specified interface, please use the no ip address command.
This command applies to the routed port, the port-channel interface and the
VLAN interface.
Syntax
ip address-alloc { dhcp | bootp }
no ip address
Parameter
dhcp —— Specify the Layer 3 interface to obtain IP address from the DHCP
Server.
bootp
—— Specify the Layer 3 interface to obtain IP address from the
BOOTP Server.
Command Mode
Interface Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the DHCP Client function on the Lay 3 routed port 1/0/1:
T1600G-52TS(config)# interface gigabitEthernet 1/0/1
T1600G-52TS(config-if)# no switchport
T1600G-52TS(config-if)# ip address-alloc dhcp
Disable the IP address obtaining function on the VLAN interface 2:
T1600G-52TS(config)# interface vlan 2
T1600G-52TS(config-if)# no ip address