TP-Link T1600G-52PS - Ipv6 Mld Snooping Querier Vlan; Ipv6 Mld Snooping Querier Vlan (General Query)

263
Privilege Requirement
Only Admin level users have access to these commands.
Example
Replace the source IP address of the MLD packets in multicast VLAN 2 as
fe80::02ff:ffff:fe00:0001:
T1600G-52TS(config)# ipv6 mld snooping multi-vlan-config 2
replace-sourceip fe80::02ff:ffff:fe00:0001
28.15 ipv6 mld snooping querier vlan
Description
The ipv6 mld snooping querier vlan command is used to enable the MLD
Querier function. To disable this function, please use no ipv6 mld snooping
querier vlan command.
Syntax
ipv6 mld snooping querier vlan vlan-id
no ipv6 mld snooping querier vlan
vlan-id
Parameter
vlan-id —— The VLAN that enables the MLD querier function, ranging from 1
to 4094.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable MLD Querier function on VLAN 2:
T1600G-52TS(config)# ipv6 mld snooping querier vlan 2
28.16 ipv6 mld snooping querier vlan (general
query)
Description
The ipv6 mld snooping querier vlan command is used to configure the
parameters for MLD Snooping Querier to send a general query frame. To