200
end-date
—— The end date in Absolute Mode, in the format of
MM/DD/YYYY-HH:MM.
index —— Specify the index of the absolute time-range to delete. If not
specified, all absolute time-ranges will be deleted.
Command Mode
Power Time-range Configuration Mode
Example
Create an absolute mode time-range for the PoE of the switch and specify
the date extending from 08:00 on May 5th, 2012 to 22:00 on Oct. 5th, 2012:
T1600G-52PS(config)# power time-range tRange1
T1600G-52PS(config-time-range)# absolute from 05/05/2012-08:00 to
10/05/2012-22:00
25.5 periodic
Description
The periodic command is used to create a periodic mode time-range for the
PoE time-range of the switch. The periodic time-range reccurs every week.
The Time-range takes affect only when both Absolute Time and Periodic
Time are in effect.
Repeat this command to create multiple periodic time-ranges. Up to 7
periodic time-ranges can be created in one Time-range, and their union is the
Periodic Time-range.
If no periodic time range is configured, the periodic time range takes effect all
the time from Monday to Sunday.
To delete the corresponding periodic mode time-range configuration, please
use no periodic command.
Syntax
periodic start
start-time
end
end-time
day-of-the-week
day-of-the-week
no periodic [
index
]
Parameter
start-date
—— The start time in the day in periodic mode, in the format of
HH:MM.
end-date
—— The end time in the day in periodic mode, in the format of
HH:MM.
To Next Page
Loading...
Need help?
General