TP-Link T1600G-52PS - Show System-Info; Show Image-Info

142
Test the connectivity between the switch and the network device with the IP
fe80::1234. If the destination device has not been found after 20
maxHops ,
the connection between the switch and the destination device is failed to
establish:
T1600G-52TS# tracert fe80::1234 20
17.22 show system-info
Description
The show system-info command is used to display System Description,
Device Name, Device Location, System Contact, Hardware Version, Firmware
Version, System Time, Run Time and so on.
Syntax
show system-info
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the system information:
T1600G-52TS# show system-info
17.23 show image-info
Description
The show image-info command is used to display the information of image
files in the system.
Syntax
show image-info
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.