264
return to the default configuration, please use no ipv6 mld snooping querier
vlan command.
Syntax
ipv6 mld snooping querier vlan
vlan-id
{ query-interval
interval |
max-response-time
response-time |
general-query source-ip
ip-addr
}
no ipv6 mld snooping querier vlan
vlan-id
{ query-interval
|
max-response-time
|
general-query source-ip }
Parameter
vlan-id
—— VLAN ID, ranging from 1 to 4094.
interval
—— The time interval to send a general query frame by MLD
Snooping Querier, ranging from 10 to 300 (Seconds). By default, it is 60
seconds.
response-time
—— The maximal time for the host to respond to a general
query frame, ranging from 1 to 25 (Seconds). By default, it is 10 seconds.
ip-addr
—— The source IP of the general query frame sent by MLD Snooping
Querier. It should not be a multicast IP or a broadcast IP. By default, it is
fe80::02ff:ffff:fe00:0001.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
For VLAN 2, specify its query-interval as 200 seconds, and the response-time
as 20 seconds:
T1600G-52TS(config)#ipv6 mld snooping querier vlan 2 query-interval
200
T1600G-52TS(config)#ipv6 mld snooping querier vlan 2
max-response-time 20
28.17 ipv6 mld snooping max-groups
Description
The ipv6 mld snooping max-groups command is used to configure the
maximum number of groups that a port can join in. The ipv6 mld snooping
max-groups action is used to configure the action that the port takes when it
To Next Page
Loading...
