TP-Link T1600G-52PS - Lldp Med-Tlv-Select

303
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the LLDP-MED feature for port 1/0/2:
T1600G-52TS(config)# interface gigabitEthernet 1/0/2
T1600G-52TS(config-if)# lldp med-status
30.10 lldp med-tlv-select
Description
The lldp med-tlv-select command is used to configure LLDP-MED TLVs to
be included in outgoing LLDPDU for the corresponding port. To exclude
LLDP-MED TLVs, please use no lldp med-tlv-select command. By default, All
TLVs are included in outgoing LLDPDU.
Syntax
lldp med-tlv-select { [inventory-management] [location] [network-policy]
[power-management] [all] }
no lldp med-tlv-select { [inventory-management]
[location] [network-policy]
[power-management] [all]
}
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Exclude “network policy” and “inventory” TLVs in LLDPDU outgoing from port
1/0/2:
T1600G-52TS(config)# interface gigabitEthernet 1/0/2