105
15.6 dot1x quiet-period
Description
The dot1x quiet-period command is used to enable the quiet-period function.
To disable the function, please use no dot1x quiet-period command.
Syntax
dot1x quiet-period [
time
]
no dot1x quiet-period
Parameter
time
—— The length of the quiet-period time. If one user’s authentication fails,
its subsequent IEEE 802.1x authentication requests will not be processed
during the quiet-period time. It ranges from 1 to 999 seconds and the default
value is 10 seconds.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the quiet-period function:
T1600G-52TS(config)#dot1x quiet-period
Enable the quiet-period function and set the quiet-period as 5 seconds:
T1600G-52TS(config)#dot1x quiet-period 5
15.7 dot1x timeout
Description
The dot1x timeout command is used to configure the supplicant timeout. To
restore to the default, please use no dot1x timeout command.
Syntax
dot1x timeout supplicant-timeout
time
no dot1x timeout supplicant-timeout
To Next Page
Loading...
Need help?
General