TP-Link T1600G-52PS Cli Reference Guide

114
no mac address-table filtering {[ mac-addr ] [ vid vid ]}
Parameter
mac-addr —— The MAC address to be filtered.
vid —— The corresponding VLAN ID of the MAC address. It ranges from 1 to
4094.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Add a filtering address entry of which VLAN ID is 1 and MAC address is
00:1e:4b:04:01:5d:
T1600G-52TS(config)# mac address-table filtering 00:1e:4b:04:01:5d vid 1
16.4 mac address-table notification
Description
The mac address-table notification command is used to configure global
settings of MAC address table notification.
Syntax
mac address-table notification { [ global-status enable | disable ]
[ table-full-status enable | disable ] [ interval time ] }
Parameter
global-status enable | disable —— Enable/Disable the notification function
globally.
table-full-status enable | disable —— Enable/Disable the MAC threshold
notification. With this feature enabled, a SNMP notification is generated and
sent to the network management system (NMS) when the threshold of the
switch’s MAC address table is reached or exceeded.
interval
time —— Specify the notification trap interval between each set of
traps that are generated to the NMS. The interval ranges from 1 to 1000
seconds and it’s 1 second by default.

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English