TP-Link T1600G-52PS Cli Reference Guide

150
Example
Configure the link-local address as fe80::1234 on the VLAN interface 1:
T1600G-52TS(config)# interface vlan 1
T1600G-52TS(config-if)# ipv6 address fe80::1234 link-local
18.4 ipv6 address dhcp
Description
The ipv6 address dhcp command is used to enable the DHCPv6 Client
function. When this function is enabled, the Layer 3 interface will try to obtain
IP from DHCPv6 server. To delete the allocated IP from DHCPv6 server and
disable the DHCPv6 Client function, please use no ipv6 address dhcp
command.
Syntax
ipv6 address dhcp
no ipv6 address dhcp
Configuration Mode
Interface Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the DHCP Client function on VLAN interface 1:
T1600G-52TS(config)# interface vlan 1
T1600G-52TS(config-if)# ipv6 address dhcp
18.5 ipv6 address ra
Description
This command is used to configure the interface’s global IPv6 address
according to the address prefix and other configuration parameters from its
received RA(Router Advertisement) message. To disable this function, please
use no ipv6 address ra command.
Syntax
ipv6 address ra

TP-Link T1600G-52PS Specifications

General

PoE Ports	48
Switching Capacity	104 Gbps
Forwarding Rate	77.4Mpps
PoE Budget	384 W
Power Supply	AC 100-240V, 50/60Hz
Mounting	Rack Mountable
MAC Address Table	16K
Jumbo Frame	9KB
Packet Buffer Memory	4 MB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 90% non-condensing
Layer	Layer 2+
Dimensions (W x D x H)	440 x 44 x 44 mm
Standards and Protocols	IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
Quality of Service	8 queues per port
VLAN	4K VLANs
Management	Web-based, SNMP
Security	802.1X
Ports	48 x 10/100/1000 Mbps RJ45 ports, 4 x 1G SFP slots