TP-Link T1600G-52PS Cli Reference Guide

175
Chapter 21 Port Mirror Commands
Port Mirror refers to the process of forwarding copies of packets from one or multiple ports to
a monitoring port. Usually, the monitoring port is connected to data diagnose device, which is
used to analyze the monitored packets for monitoring and troubleshooting the network.
21.1 monitor session destination interface
Description
The monitor session destination interface command is used to configure
the monitoring port. Each monitor session has only one monitoring port. To
change the monitoring port, please use the monitor session destination
interface command by changing the port value. The no monitor session
command is used to delete the corresponding monitoring port or monitor
session.
Syntax
monitor session session_num destination interface gigabitEthernet port
no monitor session session_num destination interface gigabitEthernet
port
no monitor session session_num
Parameter
session_num —— The monitor session number, can only be specified as 1.
port —— The monitoring port number.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Create monitor session 1 and configure port 1/0/1 as the monitoring port:
T1600G-52TS(config)# monitor session 1 destination interface
gigabitEthernet 1/0/1
Delete the monitoring port 1/0/2 from monitor session 1：

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English