255
Parameter
mtime
—— Specify the aging time in seconds, ranging from 60 to 600. The
default aging time is 260 seconds.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify MLD Snooping member port aging time as 100 seconds globally:
T1600G-52TS(config)# ipv6 mld snooping mtime 100
28.5 ipv6 mld snooping report-suppression
Description
The ipv6 mld snooping report-suppression command is used enable the
MLD report suppression function. When it is enabled, the switch forwards
only the first MLD report message per mulicast group to the Layer 3 device,
and the subsequent MLD reports from the same multicast group are
discarded. To disable the MLD report suppression function and forward all
the MLD reports to the Layer 3 device, please use no ipv6 mld snooping
report-suppression command. This function is disabled by default.
Syntax
ipv6 mld snooping report-suppression
no ipv6 mld snooping report-suppression
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable MLD Report message suppression function:
T1600G-52TS(config)# ipv6 mld snooping report-suppression
To Next Page
Loading...
Need help?
General