139
Example
Delete the backup image file:
T1600G-52TS# remove backup-image
17.19 firmware upgrade
Description
The firmware upgrade command is used to upgrade the switch’s backup
iamge file via the TFTP server. The uploaded firmware file will take place of
the Backup Image, and user can chose whether to reboot the switch will the
Backup Image.
Syntax
firmware upgrade ip-address
ip-addr
filename
name
Parameter
ip-addr
—— IP Address of the TFTP server. Both IPv4 and IPv6 addresses are
supported, for example 192.168.0.1 or fe80::1234.
name
—— Specify the name for the firmware file.
Command Mode
Privileged EXEC Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Upgrade the switch’s backup iamge file with the file firmware.bin in the TFTP
server with the IP address 192.168.0.148, and reboot the switch with this
firmware:
T1600G-52TS# firmware upgrade ip-address 192.168.0.148 filename
firmware.bin
It will only upgrade the backup image. Continue? (Y/N):y
Operation OK!
Reboot with the backup image? (Y/N): y
Upgrade the switch’s backup iamge file with the file firmware.bin in the TFTP
server with the IP address fe80::1234, but do not reboot the switch:
To Next Page
Loading...
Need help?
General