TP-Link T1600G-52PS - Chapter 1 Using the CLI; Accessing the CLI; Logon by Telnet

4
Chapter 1 Using the CLI
1.1 Accessing the CLI
You can log on to the switch and access the CLI by logging on to the switch remotely by a
Telnet or SSH connection through an Ethernet port.
1.1.1 Logon by Telnet
To log on to the switch by a Telnet connection, please take the following steps:
1. Click Start and type in cmd in the Search programs and files window and press the Enter
button.
Figure 1-1 Run Window
2. Telnet the switch_IP (factory setting is 192.168.0.1) in the prompt cmd window and press
Enter.
Figure 1-2 Type in the telnet command