TP-Link T1600G-52PS Cli Reference Guide

339
Command Mode
Line Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Configure the login authentication method list on the telnet terminal line as
“list1”:
T1600G-52TS(config)#line telnet
T1600G-52TS(config-line)# login authentication list1
34.17 line ssh
Description
The line ssh command is used to enter the Line Configuration Mode to
configure the ssh terminal line to which you want to apply the authentication
list.
Syntax
line ssh
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enter the ssh terminal line configuration mode:
T1600G-52TS(config)#line ssh
34.18 login authentication(ssh)
Description
The login authentication command is used to apply the login authentication
method list to the ssh terminal line. To restore to the default authentication
method list, please use the no login authentication command.

TP-Link T1600G-52PS Specifications

General

PoE Ports	48
Switching Capacity	104 Gbps
Forwarding Rate	77.4Mpps
PoE Budget	384 W
Power Supply	AC 100-240V, 50/60Hz
Mounting	Rack Mountable
MAC Address Table	16K
Jumbo Frame	9KB
Packet Buffer Memory	4 MB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 90% non-condensing
Layer	Layer 2+
Dimensions (W x D x H)	440 x 44 x 44 mm
Standards and Protocols	IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
Quality of Service	8 queues per port
VLAN	4K VLANs
Management	Web-based, SNMP
Security	802.1X
Ports	48 x 10/100/1000 Mbps RJ45 ports, 4 x 1G SFP slots