TP-Link T1600G-52PS - Show Interface Status

162
Parameter
port —— The Ethernet port number.
lagid —— The ID of the LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Clear the statistic information of all ports and LAGs:
T1600G-52TS(config)# clear counters
19.13 show interface status
Description
The show interface status command is used to display the connection
status of the Ethernet port/LAG.
Syntax
show interface status [ gigabitEthernet port ] [ port-channel lagid ]
Parameter
port —— The Ethernet port number.
lagid —— The ID of the LAG..
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the connection status of all ports and LAGs:
T1600G-52TS(config)# show interface status
Display the connection status of port 1/0/1:
T1600G-52TS(config)# show interface status gigabitEthernet 1/0/1