TP-Link T1600G-52PS Cli Reference Guide

121
Privilege Requirement
None.
Example
Display the security configuration of all ports:
T1600G-52TS(config)# show mac address-table max-mac-count
Display the security configuration of port 1/0/1:
T1600G-52TS(config)# show mac address-table max-mac-count interface
gigabitEthernet 1/0/1
16.12 show mac address-table interface
Description
The show mac address-table interface command is used to display the
address configuration of the specified port/LAG.
Syntax
show mac address-table interface { gigabitEthernet port | port-channel
lagid }
Parameter
port —— The Ethernet port number.
lagid —— The ID of the LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the address configuration of port 1/0/1:
T1600G-52TS(config)# show mac address-table interface gigabitEthernet
1/0/1
16.13 show mac address-table count
Description
The show mac address-table count command is used to display the total
amount of MAC address table.

TP-Link T1600G-52PS Specifications

General

PoE Ports	48
Switching Capacity	104 Gbps
Forwarding Rate	77.4Mpps
PoE Budget	384 W
Power Supply	AC 100-240V, 50/60Hz
Mounting	Rack Mountable
MAC Address Table	16K
Jumbo Frame	9KB
Packet Buffer Memory	4 MB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 90% non-condensing
Layer	Layer 2+
Dimensions (W x D x H)	440 x 44 x 44 mm
Standards and Protocols	IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
Quality of Service	8 queues per port
VLAN	4K VLANs
Management	Web-based, SNMP
Security	802.1X
Ports	48 x 10/100/1000 Mbps RJ45 ports, 4 x 1G SFP slots