267
T1600G-52TS(config)# ipv6 mld profile 1
T1600G-52TS(config-mld-profile)#deny
28.20 permit
Description
The permit command is used to configure the filtering mode of profile as
permit.
Syntax
permit
Command Mode
Profile Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the filtering mode of profile 1 as permit:
T1600G-52TS(config)# ipv6 mld profile 1
T1600G-52TS(config-mld-profile)#permit
28.21 range
Description
The range command is used to configure the range of the profile’s filtering
multicast address. To delete the corresponding filtering multicast address,
please use no range command. A profile contains 16 filtering IP-range entries
at most.
Syntax
range
start-ip
end-ip
no range
start-ip end-ip
Parameter
start-ip
—— Start IPv6 multicast address of the filter entry..
end-ip
—— End IPv6 multicast address of the filter entry.
To Next Page
Loading...
